Why does my Nikon D5300 only take one shot in Auto or when using flash, then work again after a few minutes?
Asked 8/16/2018
4 views
2 answers
0
My Nikon D5300 behaves normally in P/A/S/M for non-flash shooting, but in Auto mode it will only take one photo and then stops autofocusing and won’t take another shot unless I turn the camera off and back on. A similar thing happens in P/A/S/M whenever I use flash: it takes one photo, then won’t autofocus or shoot again until I restart the camera. If I wait a few minutes, it may work for one more shot. I’ve already updated firmware and reset settings. What could cause this?
Originally by Photography Stack Exchange contributor. Source · Licensed CC BY-SA 4.0
Photography Stack Exchange contributor
7y ago
2 Answers
2
Your camera is not supposed to exhibit the behavior you are describing. Something is wrong with it.
It sounds like either the flash is overheating or the flash temperature sensor is reporting an excessively high temperature condition even though there is not really such a condition.
You probably need to send it to a service facility that can diagnose and fix the problem. As always, you might also need to weight the potential cost of repair against the value of your used D5300.
Originally by user15871. Source · Licensed CC BY-SA 4.0
user15871
7y ago
0
Generated from our catalog & community — verify before relying on it.
That behavior is not normal. Based on what you described, the most likely issue is a flash-related fault—either the flash is overheating, or the camera’s flash temperature sensor is falsely detecting an overheat condition. The fact that it works again after waiting a few minutes strongly points in that direction.
Because Auto mode often uses flash automatically, it makes sense that the problem appears there even when it doesn’t in normal non-flash P/A/S/M shooting.
This is probably a hardware problem rather than a settings or firmware issue, especially since you already reset the camera and updated firmware. The practical next step is to have the camera checked by a Nikon service center or repair shop. Since the D5300 is an older body, it’s also worth comparing the repair cost with the camera’s current used value before proceeding.
Recommended products
UniqueBot
AI7y ago
Your Answer
Related Questions
Why is ISO grayed out in Auto mode on a Nikon D5100?
What do Nikon "Flash sync speed" and "Flash shutter speed" mean on a D7200?
Which camera exposure mode should a beginner use: Auto, scene modes, P/A/S/M?
Why can flash exposures differ slightly between P, A and S modes even with the same settings?
Canon Sure Shot AF-7 only takes one photo after loading film