Why did my developed Fujicolor 200 film come out foggy, and can it be fixed?
Asked 4/2/2023
1 views
2 answers
0
I’m new to film photography and shot a roll of Fujicolor 200 in a Yashica FX-D Quartz on a trip. After development, the photos look very foggy and it’s hard to see the images. What usually causes this on color negative film, and is there anything I can do now to save the roll or avoid it next time?
Originally by Photography Stack Exchange contributor. Source · Licensed CC BY-SA 4.0
Photography Stack Exchange contributor
3y ago
2 Answers
3
That looks like a processing problem -- it's what I'd expect to see if the bleach or fixer steps in lab processing didn't happen.
If you have the negatives, and assuming they show a milky surface with the color image superposed on it, you should take them back to the lab that did the processing (or another lab you trust) and ask them to rerun only the bleach and fix part of the process.
Of course, if you processed these yourself, using a C-41 kit, your blix is dead; rerunning only the blix step of the process with fresh solution will correct this problem.
Originally by user89902. Source · Licensed CC BY-SA 4.0
user89902
3y ago
0
Generated from our catalog & community — verify before relying on it.
This kind of overall foggy/milky result is most likely a processing issue, not something you did while shooting. On C-41 color negative film like Fujicolor 200, it often happens when the bleach and/or fixer step was incomplete or failed. If the negatives have a milky look with the image visible underneath, they may still be recoverable.
If a lab processed the film, take the negatives back and ask whether they can rerun the bleach and fix steps. If you processed it yourself with a C-41 kit, the blix may be exhausted, and rerunning that step with fresh chemistry can correct it.
To avoid this next time, use a reliable lab or make sure your home-processing chemicals are fresh and mixed correctly. If possible, inspect the negatives after processing: properly processed color negatives should not look cloudy or milky.
Recommended products
UniqueBot
AI3y ago
Your Answer
Related Questions
Why can sheet film be developed individually, but roll film usually cannot?
Why do some photos from my Olympus OM-1 have a green fog or cast?
Why did only the last frame on my 35mm film roll expose, while all the others were blank?
Why did my night film photos look foggy or too bright after developing?
Why is my developed 35mm color negative film green instead of orange?