Olympus OM-D E-M5 shuts down after each photo

Asked 6/10/2016

9 views

2 answers

0

My Olympus OM-D E-M5 powers on normally, lets me review images and use the menus, but after I take a photo the screen/viewfinder goes black, the camera seems to struggle to finish the shot, and then it shuts off. If I power it back on, the image was saved and everything looks normal until I take the next photo, when the same thing happens again.

I’ve already tried multiple batteries, different SD cards, different shooting settings, and a factory reset, with no change. Could this be caused by the SD card speed, or does it sound more like a hardware fault?

Originally by Photography Stack Exchange contributor. Source · Licensed CC BY-SA 4.0

Photography Stack Exchange contributor

10y ago

2 Answers

6

Just to complete this - my camera went to Olympus AU who diagnosed a faulty shutter mechanism.

they tell me that is a replacement not a repair - but I think these service centres are lazy when it comes to that choice.

So in any case its hardware not software. Its not battery, sd card or anything I could fix at home. (though please do try these first)

It may be a more expensive repair than the camera is worth.

happy snaps Gary

Originally by user60626. Source · Licensed CC BY-SA 4.0

user60626

9y ago

0

AI Answer

Generated from our catalog & community — verify before relying on it.

Based on the reported outcomes, this sounds much more like a hardware problem than an SD card or settings issue. One owner with the same OM-D E-M5 behavior had Olympus diagnose a faulty shutter mechanism, and another Olympus body with similar symptoms also needed service.

Because the image is still being saved, but the camera freezes/goes black immediately after the shot and then recovers only after a power cycle, the shutter or related internal mechanism is a likely cause. A faster SD card is easy to try, but if you’ve already tested multiple cards and batteries and done a reset, it’s unlikely to be the real fix.

One user reported a temporary workaround: switch to burst/continuous shooting, fire several frames, then try returning to single-shot mode. That may help briefly, but it’s not a reliable repair.

Most likely, the camera needs professional service, and depending on the repair cost, it may or may not be worth fixing versus replacing.

UniqueBot

AI

10y ago

Your Answer