How do I use a wireless shutter release, and do I need Bulb mode?
Asked 8/25/2011
1 views
2 answers
0
I bought a wireless shutter release, but the instructions are very minimal. How do you typically set up and use a wireless remote shutter release? Do I need to put the camera in Bulb mode, or can I use it in Av, Tv, or M mode?
Originally by Photography Stack Exchange contributor. Source · Licensed CC BY-SA 4.0
Photography Stack Exchange contributor
15y ago
2 Answers
6
You normally have to set the camera to accept the remote signal. This can be found sometimes with the drive modes or self-timer, it really depends on your model.
Once the camera is ready. Aim at one of the IR receptors and click the release. Some cameras have a front receptor, some have a back one and some have both. Look for what looks like a small very dark window.
The camera can be in any mode and it will take the shot accordingly. Most models will not autofocus when used with the remote, some will let you specify this as an custom setting.
Bulb mode either works by holding the release the whole time (which IMO is silly) or by clicking at the beginning and end of the internal. A few DSLRs allow both and the behavior is chosen via a custom setting.
Originally by user1620. Source · Licensed CC BY-SA 4.0
user1620
15y ago
0
Generated from our catalog & community — verify before relying on it.
In general, a wireless shutter release works in whatever exposure mode you choose: Av, Tv, M, and Bulb can all work. You only need Bulb mode for exposures longer than your camera’s normal shutter-speed range.
Typical setup:
- Enable remote release on the camera. This is often in the drive mode, self-timer, or remote-control menu, depending on the camera.
- If it’s an infrared remote, point it toward the camera’s IR receiver window. Some cameras have a receiver on the front, back, or both.
- Press the remote button to take the shot.
Notes:
- Many cameras do not autofocus when triggered remotely, though some models allow this through a custom setting.
- If your remote uses a receiver plugged into the camera’s remote port, operation is similar, but you don’t need line-of-sight like IR remotes do.
- In Bulb mode, the remote may work in one of two ways: hold the button down for the whole exposure, or press once to start and again to stop. Some remotes/cameras also support a lock function for long exposures.
Recommended products
UniqueBot
AI15y ago
Your Answer
Related Questions
How should I set up a Nikon D610 and remote for long-exposure car light trails?
Can Canon Rebel cameras use Bulb mode with a wireless remote?
Why does my Nikon D5200 show Time instead of Bulb in Quick-Response Remote mode?
How do I make exposures longer than 30 seconds on a Nikon D7000 with a wireless remote?
How do I use an infrared remote with a Canon EOS 7D Mark II?