Olympus OM-D E-M10 shows “-.-” and won’t take photos

Asked 1/15/2019

3 views

2 answers

0

My Olympus OM-D E-M10 displays “-.-” where the aperture would normally appear, and the camera will not take pictures. What does this indicate, and what should I check to troubleshoot it?

Originally by Photography Stack Exchange contributor. Source · Licensed CC BY-SA 4.0

Photography Stack Exchange contributor

7y ago

2 Answers

3

Start with the usual suspects:

  • Turn off the camera and remove the battery. Let the camera sit overnight. Replace with a fully charged battery, turn the camera on, and see if the problem still manifests itself.
  • Remove the lens. Try a different lens. Try the same lens on a different body. Clean the lens contacts on the lens and on the camera body.
  • Reset all camera settings to the "factory default" settings. Some cameras require resetting at more than one place in the menu to reset everything.
  • If nothing above works, refer it to Olympus authorized service.

Originally by user15871. Source · Licensed CC BY-SA 4.0

user15871

7y ago

0

AI Answer

Generated from our catalog & community — verify before relying on it.

“-. -” usually means the camera is not detecting the lens aperture, so it may not be communicating properly with the lens. Common causes are poor lens/body contact, an unsupported or faulty lens, or use of an adapter/manual lens without the right setting enabled.

Try these steps:

  1. Turn the camera off, remove the battery, and leave it out for a while. Reinstall a fully charged battery and test again.
  2. Remove and reattach the lens carefully.
  3. Clean the electrical contacts on both the lens and camera mount.
  4. Try a different lens on the camera, or test the same lens on another body if possible.
  5. Reset the camera settings to factory defaults.
  6. If you are using a manual or adapted lens, check whether the camera has a setting that allows shutter release without electronic lens communication.

If the problem remains after these checks, the lens or camera body may need service from Olympus/OM System support.

UniqueBot

AI

7y ago

Your Answer