• For connecting a PocketWizard radio (including FlexTT5) to any flash equipped with a PC terminal
• For connecting a camera or lens PC to a transmitting PocketWizard radio (except MiniTT1 and FlexTT5)
• Cable length: Coiled: 1' (30.5 cm) extended
• From 1/8" (3.5 mm) mono miniphone
• To locking PC male
• Compatible with most camera or flash PC terminals, including non-locking and locking ring-equipped models

- Blue, 10 Pack
- Secure cables
- Washable
- UV resistant
- Double "O" Ring Buckle
- Tested in extreme temperatures
- Life Cycle of Over 10,000 Closures

- Black, 10 Pack
- Secure cables
- Washable
- UV resistant
- Double "O" Ring Buckle
- Tested in extreme temperatures
- Life Cycle of Over 10,000 Closures

- Blue, 50 Pack
- Secure cables
- Pull-Through Design
- Light & Thin

- Red, 10 Pack
- Secure cables
- Washable
- UV resistant
- Double "O" Ring Buckle
- Tested in extreme temperatures
- Life Cycle of Over 10,000 Closures

• Renamed as the N10-ACC
• Pre-Trigger Remote Cable
• Cable lengths: 3' (91.5 cm) and 1' (30 cm
• From: 1/8" (3.5 mm) stereo miniphone
• To: Nikon 10-pin remote shutter release terminal
• Pre-Trigger cable controls both the half-press and full-press function of your remote camera’s shutter release
• Contains a "no diode" circuit necessary only for the newer Nikon cameras
• Compatible with: PocketWizard: PlusX, Plus III, FlexTT5, MultiMAX with ACC port to a Nikon 10-pin remote shutter release terminal, For the Plus II, older MultiMAX or other PocketWizard radios, Please use a N90M3 or a N90M3-P cable
  Cameras: Nikon N90, N90S, F5, F6, F100, D1, D1H, D1X, D2H, D2Hs, D2X, D2Xs, D3, D3s, D3X, D4, D300, D300s, D700, D800, D800E

• For connecting a PlusX,  Plus III, FlexTT5 or MultiMAX with ACC port
• Cable lengths: 3' (91.5 cm) and 1' (30 cm)
• From: 1/8" (3.5 mm) stereo miniphone
• To: Nikon 10-pin remote shutter release terminal
• Compatible with: PlusX, Plus III, FlexTT5, MultiMAX with ACC port to a Nikon 10-pin remote shutter release terminal, For the Plus II, older MultiMAX, or other PocketWizard radios, please use a N90M3 or N90M3-P cable
• Compatible with: Nikon N90, N90S, F5, F6, F100, D1, D1H, D1X, D2H, D2Hs, D2X, D2Xs, D3, D3s, D3X, D4, D300, D300s, D700, D800, D800E,
  Kodak DCS ProSLR/n, DCS Pro 14n, DCS 760, DCS 720x, DCS 660, DCS 660M, DCS 620, DCS 620x, Fuji S3 Pro, S3 Pro UV IS, S5 Pro, IS Pro

   

• For adapting a -ACC stereo miniphone remote camera cable to a mono miniphone pre-trigger cable
• From 1/8" (3.5 mm) mono miniphone
• Pre-trigger switch allows you to selectively wake or sleep camera
• To 1/8" (3.5 mm) stereo miniphone
• Must be used with a -ACC Remote Camera cable
• Converts -ACC cable to a Pre-Trigger (-P) cable
• Compatible with: FlexTT5, PlusX, MultiMAX, Plus II, Plus III and older radios

• Adapts a 3/32" (2.5 mm) stereo or mono sub miniphone cable to a miniphone sync terminal
• From 1/8" (3.5 mm) stereo miniphone female
• To 3/32" (2.5 mm) sub-miniphone female
• Compatible with electronic flashes equipped with a 3/32" (2.5 mm) sub-miniphone sync terminal including Metz: 20BC-6, 34CS2, 70MZ, 32CT, 40MZ, 76MZ, 32MZ, 50MZ, 32Z, 54MZ, compatible Metz SCA adapters, Canon T3 adapter, Elan, F1, Contax 645, Olympus and Bronica motor drives and select digital backs that require external sync

- Black, 50 Pack
- Secure cables
- Pull-Through Design
- Light & Thin

- White, 10 Pack
- Secure cables
- Washable
- UV resistant
- Double "O" Ring Buckle
- Tested in extreme temperatures
- Life Cycle of Over 10,000 Closures

• For remotely triggering a flash via a standard hot shoe
• Does not Support TTL Functions
• Cable Length:  3' (91 cm) straight
• From 1/8" (3.5 mm) mono miniphone
• To Standard hot shoe
• Includes a 1/4-20 thread mount
• Compatible with: PlusX, Plus III, MultiMAX, FlexTT5 (for non-TTL flashes), Older PocketWizard radios, including Plus, Plus II, etc.
• Compatible with flashes that work with a standard hot shoe, including Bower, Canon, Cheetah, Fuji, Godox, Leica, Lumopro, Metz, Nikon, Nissin, Olympus, Panasonic, Pentax, Phottix, Quantum, Sigma, Sunpak, Yongnuo And any other flash with a standard ISO 518 hot shoe

- For Canon DSLRs
- Compatible with AlienBees & White Lightning, Zeus Power Packs
- ControlTL
- Manual Power Control
- ZoneControl
- HyperSync
- Low-Profile Design
- No batteries required

- Yellow, 10 Pack
- Secure cables
- Washable
- UV resistant
- Double "O" Ring Buckle
- Tested in extreme temperatures
- Life Cycle of Over 10,000 Closures

- Connects to 10-Pin Terminal
- Transmitter Runs on DSLR Battery

• Pre trigger Cable
• For connecting a PlusX, Plus III, FlexTT5 or MultiMAX with ACC port
• Cable lengths: 3' (91.5 cm) and 1' (30 cm)
• From: 1/8" (3.5 mm) stereo miniphone
• To: Canon E3 remote shutter release terminal or sub miniphone
• Compatible with: PocketWizard: PlusX , Plus III, FlexTT5, MultiMAX with ACC port, For the Plus II, older MultiMAX, or other PocketWizard radios, we recommend using the CM-E3-P or CM-E3
  Cameras: using Canon's E3 remote terminal or sub-miniphone connector including
  Canon EOS ELAN II, EOS DIGITAL REBEL, EOS Rebel T1i, EOS ELAN IIE, EOS DIGITAL REBEL XT 
  EOS Rebel T2, EOS ELAN 7, EOS DIGITAL REBEL Xti, EOS Rebel T2i, EOS ELAN 7E, EOS DIGITAL REBEL Xsi, EOS Rebel T3, EOS ELAN 7N 
  EOS REBEL 2000, EOS Rebel T3i, EOS ELAN 7NE, EOS REBEL IX Lite, EOS REBEL GII, EOS REBEL XS, EOS REBEL G, EOS 60D, EOS REBEL IX, EOS 450D, EOS REBEL T2 EOS 400D, EOS REBEL Ti, EOS 350D, EOS REBEL X, EOS 300D, EOS REBEL T4i, EOS 1000D
  Bronica ETR motor drive, SQA series 
  Hasselblad H1, H1D, H2, H2D, H2D-39, H2F, H3D, H3DII 
  Contax 645 series, N series 

• For adapting a -ACC stereo miniphone remote camera cable to a mono miniphone cable
• For use with a Plus II or older MultiMAX top port
• From 1/8" (3.5 mm) stereo miniphone
• To 1/8" (3.5 mm) mono miniphone
• Must be used with a -ACC remote camera cable
• -ACC cable sold seperately
• Compatible with all Plus II, MultiMAX top port, and older radios

   

- 5 Foot Coiled Cords Unextended - 21 inches. Extended - Up to 5 feet. Outside diameter - .155 inches.

- Very Small Remote Control System - Can Sync At Up to 1/150s in Normal Mode - 8 Frequencies Available - 4 Workgroups Possible - Range: Indoor-165'/Outdoor-395' - Movable Antenna Optimizes Reception

- Provides sync capabilities to any manufacturers flashhead and can control flash power and modeling lamps for RX flashheads and battery packs - Includes Hotshoe with Sync socket - Test button for manual flash trigger - Long life Lithium battery provides 50,000 flashes per charge - No limit to the number of lights that the Transmitter can control

- Hot shoe slave trigger

- Strato II Multi 5 in 1 Wireless Trigger System - Shutter Release - For Canon

- Strato II Wireless Trigger System - Shutter release - For Canon

- Strato II Multi 5 in 1 Wireless Trigger System - Shutter release - For Nikon

- Cable length: 3' (91.5 cm) - From Canon T3 Motor Drive - To Pre -Trigger Switch - To 1/8" (3.5 mm) Mono Miniphone

• MH3 Flash Sync Cable
• For remotely triggering a flash equipped with a household sync terminal
• Cable length: 3" (91 cm)
• From 1/8" (3.5 mm) mono miniphone
• To household male sync terminal
• Compatible with flash models using a household sync terminal including:
  • Comet, Dyna-Lite, Lumedyne, Norman, Novatron, Quantum, Speedotron, Sunpak 120J/555/622

• MM1 Flash Sync Cable
• For remotely triggering a flash equipped with a 1/8" (3.5mm) mono miniphone sync terminal
• Cable length: 1' (30 cm)
• From 1/8" (3.5 mm) mono miniphone male
• To 1/8" (3.5 mm) mono miniphone
• Compatible with flash models using a 1/8" (3.5 mm) mono miniphone sync terminal including:
• AlienBees, Elinchrom Digital RX Series, Broncolor, Elinchrom Digital Style Series, Multiblitz, Elinchrom Micro Compact Digital, Profoto D1 series, Elinchrom Style 400BX, Savage, Elinchrom Style S, Visatec, Photogenic Studio Max Lights, JTL AC slaves, JTL J-110 & J-160 Versalights, JTL Mobilights

• MP1 Flash Sync Cable
• For remotely triggering a flash equipped with a 1/4" (6.35mm) phono sync terminal
• Cable length: 1' (30 cm)
• From 1/8" (3.5 mm) mono miniphone
• To 1/4" (6.35 mm) mono phone male
• Compatible with flash models using a 1/4" (6.35 mm) phono sync connector including:
  • Balcar , Dynalite Road/RoadMax, Bowens, Interfit / Paterson, Calumet, JTL Versalights (Not J-110 or J-160*), Hensel, Photogenic, Impact, Profoto (Not D1 series*), Norman, SP Studio System, Photek, White Lightning